•X-2 Lanyard Plate
--Rerelease date: June 1st, 2016
--JAN code: 456212143 824 8
|X-2 Lanyard Plate|
|X-2 Lanyard Plate installed on X-2 for EOS70D|
■ Product features ■
Attaching this plate on INON “X-2 for EOS6D” or “X-2 for EOS70D” housing utilizes to use commercially available lanyard (carry belt).
The plate is attached on the “Base Adapter Fixing Screw Hole (M6)” of the compatible housing by screws or by compatible INON arm adapter.
Supplied rubber grommet prevents uncomfortable clinking noise between this product and metal hook from recording when shooting video as well as scratching the housing body.
●Compatible X-2 series housing (*1)
•X-2 for EOS6D
•X-2 for EOS70D
●Compatible arm system products (*2)
•Multi Direct Base IIa
•Multi Direct Base II WB
•Multi Direct Base II Long
•Shoe Base Adapter X-2 + Shoe Base
•M6 Plate Direct Base III + Direct Base III
•M6 Plate Direct Base III + Direct Base YS RT
It is possible to attach this product to X-2 for EOS10D, X-2 for EOS20D, X-2 for EOS30D, X-2 for EOS50D/40D or X-2 for EOS60D but it requires to remove pre-installed “Lanyard hook”. Please consult with your purchasing dealer. Not compatible with an INON housing which has done “Sync Connector Installation”.
Attaching “ClampⅢ”, “Z Joint” or “Light Holder products” may interfere full movement of the lanyard.
|X-2 Lanyard Plate + Multi Direct Base IIa (right)|
X-2 Lanyard Plate + Shoe Base Adapter X-2 + Shoe Base (left)
|X-2 Lanyard Plate + M6 Plate Direct Base III + Direct Base III (right)|
X-2 Lanyard Plate + M6 Plate Direct Base III + Direct Base YS RT (left)
|Stainless spring snap hook linked to |
X-2 Lanyard Plate (with a rubber grommet)
|Split ring attached on X-2 Lanyard Plate|
|A carrying rope attached on X-2 Lanyard Plate|
・X-2 for EOS6D
・X-2 for EOS70D
May 31st, 2016
*Press release information is as of May 31st, 2016 and subject to change without prior notice.